Selco - wnt 200 14' rear load panel saw

UpUp


Subject: Selco - wnt 200 14' rear load panel saw
MACHINE: 1993 SELCO - WNT 200 14' REAR LOAD PANEL SAW
CONDITION: RECENTLY TAKEN OUT OF OPERATION
LOCATION: UWMO WAREHOUSE (USA)
* Capacity 174" overall cutting length.
* 132 mm saw blade projection.
* Automatic blade height adjustment.
* Electronic scoring adjustment through the controller.
* Scoring unit for regular pre-scoring.
* Equipped with 34" stack height automatic lift table for side or rear loading.
* Lift table specifications: 181" x 86".
* 4 HP motor for raise and lower.
* Easy loading of plywood lifts.
* Encoder controlled guide rods for automatic book height adjustments.
* Side aligning device and 3 logitudinal aligners to accurately position book of panels on rear saw table prior to cutting.
* Equipped with: 10 clamps (open up to 5.1") of which 4 are closely spaced in crosscut area and the other 6 are at equal distance in rip cut area.
* CNI "Digiset" electronic controller with graphic monitor with floppy.
* 400 cutting patterns with 50 different dimensions for each pattern.
* C/W 2nd full length pressure beam for clamping panels on the last trim cut.
* 2,300 mm long crosscut fence (front to back).
* "Quick Change" saw blade replacement system.
* 4 front mounted air float tables for moving panel from rip to crosscut position (24" x 81") each.
* Rear of machine enclosed for safety with wire screen panels.
-With Offices In Both Canada & United States -