45- 5 gal solvent roofing bonding adhesive


Subject: 45- 5 gal solvent roofing bonding adhesive
"Over 30 years expierence in single ply flat roofing products!"
Click Below for Certification, Qualification and Reference Data
This is a full pallet lot of 45 - 5 gal pails of bonding adhesive at 1,800 lbs and is Class C-60, UN1133. This is enough professional grade adhesive to cover 15,000 square feet of roof membrane and insulation and or decking. It is necessary to use this professional grade adhesive to secure your roof membrane properly to the substrate.
Wholesale roofing price at only $54.00 per 5 gal pail!!
200 page Specification & Installation guideline online manual available at
We have both WHITE TPO rubber and BLACK EPDM rubber roofing.
The EPDM membrane may be installed in a fully adhered application directly over 1/2" or larger plywood decking, APPROVED DECKING OR APPROVED INSULATION, if the deck support is considered adequate for the roof load as determined by the local installer, and the roof installation meets local building codes.
Position the EPDM membrane over the substrate, wood decking, concrete, or insulation, without stretching the sheet. Allow sufficient materials for perimeter attachment. When the new membrane is to be sealed to an abutting membrane, overlap the edge of the new membrane 5 onto the "in place" membrane.
Bond the new sheet to the substrate by folding the sheet lengthwise on to itself so that one half of the underside is exposed. Smooth out all the wrinkles and buckles along the folded edge. Apply the bonding adhesive evenly at the rate of 120 sq. ft. per gallon per surface using a 9" plastic core paint core paint roller or approved spray application equipment. Allow the adhesive to dry until it is tacky and string free to the touch. Roll the membrane onto the substrate taking care to avoid wrinkling by using a "wave" air motion at the leading edge to "roll" the sheet into place. Bond the adhered half of the membrane with a 18" to 24" heavy duty push broom using a pushing motion to achieve maximum contact. Pull back the unbonded half of the sheet and repeat this procedure. Do not apply adhesive to the top surface of any abutting membrane that is to be used as the seam joint.
EMAIL US for any additional information or if we may assist you in combining freight charges
Summary of My Selling Policies
No sales taxes UNLESS in specific states locals
Returns accepted on qualified items with RGA return number
Read my policies on my SquareTrade Seal