Up
|
VERRINA MODEL CLR540/4050 4-ROLL HYDRAULIC PLATE BENDING ROLL* Capacity: 13' x 1.58" (Mild Steel) Length of Rolls: 13'3" Diameter of Top and Lower Roll: 27.6" Diameter of Side Rolls: 22.8" (4) Roll Drive (3) Rolling Speeds: 78.7 IPM, 137.8 IPM & 216 IPM (2) Pinch Rolls Vertical Speeds: 7.8 IPM & 12 IPM (2) Forming Roll Vertical Speeds: 9 IPM & 13.9 IPM Length of Pinch Roll Adjustment: 5.2" Hydraulic Adjustment to Bottom and Side Rolls EQUIPPED WITH: Operator Control Console Hydraulic Drop End Housing Cone Rolling Hydraulic Power Supply System 87 HP AC Main Drive (Pump) Motor Electrical Controls Approximate Overall Dimensions: 337" L-R x 130" F-B x 180" H Approximate Weight: 204,000 Lbs. Serial Number: 11895 (New 1977) P2 F.O.B. LEICESTER,UK - $170,000.00 * PRELIMINARY SPECIFICATIONS SUBJECT TO VERIFICATION Email us at Call our Sales Staff at Prices do not include any federal, state or local taxes, which are in addition to the purchase price and must be paid by the Purchaser. Any and all foreign duties and taxes are the responsibility of Purchaser. Unless Purchaser furnishes PMS with a tax exemption certificate, any sales, use, excise, or other similar tax, where applicable, shall also be the responsibility of Purchaser and may, at the election of PMS, be added to the quoted purchase price and invoiced by PMS to Purchaser. The failure of PMS to invoice such taxes does not excuse the Purchaser from responsibility for paying necessary taxes. Some machinery and equipment is located at Fortune 100 Manufacturing Facilities. Most of the machinery and equipment located at these Facilities is disconnected and cannot be seen under power. Unless specifically listed in writing by PMS, all machinery and equipment uses 3 Phase power. (outside US & Canada) Email: |