Smtw M1450A/2000 universal cylindrical grinder


Subject: Smtw M1450A/2000 universal cylindrical grinder
Work Area: 20" x 80"
Work I.D.: 1.2" - 7.9"
Work O.D.: .99" - 20"
Center Height: 10.6"
Workload: 3,000 Lbs (Maximum)
Wheel Size: 15" - 20" O.D. x 12" I.D. x 3" W
Wheel Speed: 665 - 1330 RPM
Wheel Surface Speed: 3485 - 6969 FPM
Wheelhead Rapid Travel: 30 IPM
Spindle Taper: 1:5
I.D. Spindle Speed: 10,000 - 15,000 RPM
Worktable Maximum Travel: 80"
Worktable Angle: 20 Degree
Worktable Feed Range: 4 - 157 IPM
Worttable Swivel: -2 Deg./+5 Deg.
Workhead Spindle Speeds: 23, 32, 46, 64, 90, 125
180 and 250 RPM
Workhesd Taper: 6 MT; Workhead Swivel: 90 Degree
Workhead Through Hole Dia.: 1"
Tailstock Quil Travel: 2.75"; Tailstock Taper: 6MT
Accu-Rite Master-TP Programmable 2-Axis Didital Readout
Flood Coolant System
3-Jaws Chuck (12" Dia.)
Steady Rest; Follower Rest; Wheel Flanges
Wheel Periphery Dresser; Wheel Balancing Arbor & Stand
Hydraulic Power Unit; Electrical Control
10 HP AC Main Wheelhead Drive Motor
5 HP AC Workhead Drive Motor
2 HP AC I.D. Spindle Drive Motor
Approximate Overall Dimensions: 240" L-R x 96" F-B x 70" H
Approximate Weight: 22,000 Lbs.
Serial Number: 658 (New 1994)
P2 F.O.B. Elk Grove, IL - $ 69,500.00
Email us at
Call our Sales Staff at
Prices do not include any federal, state or local taxes, which are in addition to the purchase price and must be paid by the Purchaser. Any and all foreign duties and taxes are the responsibility of Purchaser. Unless Purchaser furnishes PMS with a tax exemption certificate, any sales, use, excise, or other similar tax, where applicable, shall also be the responsibility of Purchaser and may, at the election of PMS, be added to the quoted purchase price and invoiced by PMS to Purchaser. The failure of PMS to invoice such taxes does not excuse the Purchaser from responsibility for paying necessary taxes.
Some machinery and equipment is located at Fortune 100 Manufacturing Facilities. Most of the machinery and equipment located at these Facilities is disconnected and cannot be seen under power. Unless specifically listed in writing by PMS, all machinery and equipment uses 3 Phase power.
(outside US & Canada)