Pines 1 bender


Subject: Pines 1 bender
Maximum Tube Radius: 10"
Maximum Tube Length Over Mandrel: 9'6" (Approx.)
Maximum Bend Angle: 180 Degrees
Average Maximum Bending Arm Speed: 17 RPM; Speed Control Valve
Standard Operating Pressure: 1,000 PSI
Clockwise Rotation
Automatic Hydraulic Mandrel Extractor
Plane-of-Bend; Pressure Die Assist
Pressure Die Holder; Bijur Automatic Slide Lubricator
(10) Station Degree of Bend Selector; Swinging Arm Safety Device
Push Button Operation (Pedestal Mounted)
5 HP AC Main (Pump) Motor 230/460/3/60 Currently 230
Electrical Controls (Separate, Free-Standing Cabinet)
I.P.S. Extra Heavy Pipe: 1"
Non-Ferrous Tubing Y.P. to 12,000 PSI: 1-3/4" O.D. x .188" Wall
Non-Ferrous Tubing Y.P. to 25,000 PSI: 1-3/4" O.D. x .120" Wall
Steel Tubing Y.P. TO 40,000 PSI: 1-3/4" O.D. x .072" Wall
Stainless Steel Tubing Y.P. TO 60,000 PSI: 1-3/8" O.D. x .065" Wall
Steel Bar Round Y.P. to 40,000 PSI: 7/8" Diameter
Steel Bar Square Y.P. to 40,000 PSI: 3/4"
Angle Iron Y.P. to 40,000 PSI: 1-1/2" x 1-1/2" x 3/16"
Square Tube (Mild Steel): 1-1/8" x .120" Wall
Rectangular Tubing (Mild Steel) E-Plane: 1" x 1-1/2" x .120"
Rectangular Tubing (Mild Steel) H-Plane: 1" x 1-1/2" x .083"
Approximate Overall Dimensions: 162" L-R x 48" F-B x 45" H
Approximate Weight: 4,000 Lbs.
Serial Number: 11035-81242 (New 1981)
P2 F.O.B. Elk Grove, IL - $ 17,500.00
Email us at
Call our Sales Staff at
Prices do not include any federal, state or local taxes, which are in addition to the purchase price and must be paid by the Purchaser. Any and all foreign duties and taxes are the responsibility of Purchaser. Unless Purchaser furnishes PMS with a tax exemption certificate, any sales, use, excise, or other similar tax, where applicable, shall also be the responsibility of Purchaser and may, at the election of PMS, be added to the quoted purchase price and invoiced by PMS to Purchaser. The failure of PMS to invoice such taxes does not excuse the Purchaser from responsibility for paying necessary taxes.
Some machinery and equipment is located at Fortune 100 Manufacturing Facilities. Most of the machinery and equipment located at these Facilities is disconnected and cannot be seen under power. Unless specifically listed in writing by PMS, all machinery and equipment uses 3 Phase power.
(outside US & Canada)