Up
|
Maximum diameter ground with new wheel Maximum grinding length between centers Maximum workpiece weight between centers Table traverse per handwheel revolution Table traverse fine feed graduations Table traverse steplessly variable per minute Minimum table stroke under hydraulic control Table swivel adjustment-included angle clockwise/ included angle anti-clockwise Infeed rate at table reversal, reduction in work Wheelhead feed handwheel-rapid/standard feed per revolution, reduction in work diameter Workhead swivel, clockwise/counter-clockwise Workhead and tailstock spindle center taper Standard grinding wheel (Type EIU wheelhead) Wheelhead swivel adjustment each side of normal 12" diameter x 1" wide x 5" bore Manually operated or hydraulically actuated table traverse Manually operated, Automatic Intermittent (at table reversal), and Automatic Continuous (Plunge grinding) modes of wheelhead infeed Swing-around internal grinding attachment with spindle 3/4 H.P. 3/60/220-440 volt motorized workhead with 6" diameter four-jaw chuck, 6- 1/4" diameter magnetic chuck, and combination live/dead center Tailstock with assorted full and half centers (1) 5/16"-3" Diameter capacity three-point plain-type steady rest (1) 5/16"-3" Diameter capacity two-point open-type steady rest Table mounted diamond holder for dressing wheel Self-contained hydraulic system with 1 H.P. motor External coolant pump and tank Manully operated one-shot lubrication system 5.5 H.P. 3/60/220-440 volt wheelhead motor and electrical controls Machine is wired for 220 volt operation. 66" L-R x 53-1/2" F-B x 69" High (F.O.B. Truck, Hauppauge - Long Island, NY) |